Ironcompany 12 Bar Wall Mount Olympic Bar Vertical Storage Rack – The Wall Mount 12 Bar Holder from Ironcompany is an American-made heavy duty steel storage rack hung horizontally on the wall for vertical storage of up to twelve Olympic weight bars. Group training facilities such as crossfit boxes, fitness boot camps, and sports performance centers will often have up to a dozen Olympic weightlifting bars or Olympic power bars in use on the training floor at once. Rather than cluttering up the floor, many facilities will lean numerous bars grouped together against the wall or into a corner. However, this creates safety and liability issues should a bar resting upright and unsecured happen to roll and fall over onto mirrors, equipment, athletes, or coaches. In addition, repeated impact on bar ends to the ground when storing in such a fashion over time can dent or dull bar sleeve caps and cause premature wear on bar sleeve fasteners. The wall mounted barbell rack gets your bars off the floor and onto your wall to better organize your space and offer easier access to group members in your facility. This Olympic weight bar wall rack accommodates both long and short bars since the bar will hang downward from the inside collar at the end of one sleeve. The spacing between each rung of the hanging bar rack is wide enough to fit traditional barbell shafts from 25mm to 32mm in diameter on men’s 20kg Olympic weight bars, women’s 15kg Olympic training bars, and even lighter aluminum technique bars (but not fat bars or axle bars). The barbell holder is built tough from 11 gauge steel that is laser cut for an attractive look and finished with a durable black powder coated finish for longevity. Three pre-drilled mounting holes allow for secure installation and line up perfectly with traditional 16″ center-on-center construction spacing of wooden studs. Olympic bars as shown in stock photos are for demonstration purposes only and are NOT included.
Single wall mounted horizontal bracket holds up to 12 Olympic Bars vertically. 48″ L x 5″ H x 3.5″ D
MADE IN USA. 11-gauge steel produced by laser cutting and CNC bending. Black powder coated finish.
Accommodates both long and short bars with barbell shafts from 25mm to 32mm in diameter.
3 pre-drilled mounting holes spaced 16″ apart for standard stud wall attachment.
Intended for installation to wood studs or masonry. Mounting hardware and Olympic bars NOT included