Sale!

Robert Axle Project Resistance Trainer 12mm Thru Axle, Length: 174mm Thread: 1.75mm

$54.00 (as of December 15, 2017, 11:49 PM) $44.31

Application: Bike trainers
Installed or removed using a 5mm Allen wrench
Designed, built and tested in the USA

Continue to Amazon for more details

Description

Robert Axle Project thru axles allow modern frames to be used with axle mount trainers. IMPORTANT: Before ordering, make sure your specific trainer will accommodate the width of the thru-axle equipped bike that you are using. Axle shaft and axle ends are machined from 7075 aluminum and hard anodized. Materials: 7075 Aluminum. Installed or removed using a 5mm Allen wrench. Measure trainer at the widest setting and measure the bike frame width at the rear hub. Application: Bike trainers. For use with bike trainers such as 1up, Blackburn, Cyclops, Kinetic, Tacx and more. The Robert Axle ends will extend 15mm past the frame on each side. Designed, built and tested in the USA.
IMPORTANT: Before ordering, make sure your specific trainer will accommodate the width of the thru-axle equipped bike that you are using
Axle shaft and axle ends are machined from 7075 aluminum and hard anodized
Materials: 7075 Aluminum
Installed or removed using a 5mm Allen wrench
Measure trainer at the widest setting and measure the bike frame width at the rear hub

Additional information

Brand

Manufacturer

Continue to Amazon for more details

Please note: We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites. Certain content that appears on this site comes from AMAZON SERVICES LLC. This content is provided ‘AS IS’ and is subject to change or removal at any time.