Remove the battery cover and put a piece of CR2032 battery into the case. Notice: Positive pole (+) should be set upwards. Then cover the the battery cover and screw down.
Sensor and Magnet Installation
Install the sensor onto the front fork of bicycle, and the Magnet is installed onto the steel wire at the same side of wheel. Sensor can be underlaid with back-up plate and use the strap to fasten onto the front fork. It needs to be installed in 60cm distance from the computer. Adjust the comparative location of Sensor and Magnet. The plane must face to the inductor, keep the space to be 1.5mm. Magnet can not be set to the center of Sensor face-to-face, it’s better with the head or tail of Sensor.
In the accessories pack there has a strap which can be used to fasten the Seat onto the handlebar, as well we can use the back-up plate to fasten it.
Push the computer along the chute, the button stand fix the computer and hold. Removing it just needs to pull it out in reverse direction along the chute. Check the installation: Turn the front wheel to run, look to the screen to confirm if it’s got signal. If there has no signal or the reaction is not sensitive please adjust the relative location of Sensor and Magnet slightly.
Two Bicycle I / II using
Press the middle key for 6 seconds to change bicycle I/II.
Under the (ODO-TE-CLK) main mode, press the middle key to change to (ODO-TE-SW) mode. In this mode, press left key to start stopwatch, press again to stop it, press right key to clear the value. It ranges from 0:00:00 to 9:59:59.
★ Current Speed Current speed will be showed when you are on riding. Precision at 0.1KM/h. It ranges from 0~99.9 KM/h(M/h).
★ Resetting: Press both middle and right key for 3 seconds to reset KM /h M/hr, wheel Perimeter/ ODO /weight/ Maintenance alert.
★ Memory function All cycling and setting data will be kept after changing battery.
★ 20 Functions: 1. Used on two kinds tyre spec 2. Memory function 3. Speed tendency 4. Current Speed 5. Odometer 6. Distance of single trip 7. Max speed 8. Average speed 9. Time of ride 10.(12h|24h)Clock 11. Calories Level 12. Fat burn measureement 13. Temperature 14. Time (seconds watch) 15. Indication for low power 16. Maintenance and reminding function 17. Adaptable for KMhr or Mhr 18. SETTING WHEEL CYCLING (0mm-99999mm) 19. Default value of odometer setting 20. Auto on off
★ Package includes: 1 x Stopwatch display (without retail package) 1 x Inductive head 1 x Bicycle computer base 1 x Fixed ties 1 x Data sensing lines 2 x Double-sided adhesive