Note: This part is 3D printed and will not identically match the look/finish of your OEM piece. Printed in the USA! The design is 1 piece with an integrated button. That means this piece replaces the button, the band or cover the charger plugs into, and the spring plate in one piece. A major issue with the OEM design was due to small pieces that could easily be lost, that has been eliminated in this design. My piece is specifically made to replace a piece that was broken off (not a piece carefully removed to replace a broken wrist band, even though it would replace this too). You will not see 4 pins on the inside as this would complicate replacement because most break inside the fitbit when the piece breaks off. That means you only need to superglue it on and don’t need to worry about carefully extracting the pins from your fitbit. Please validate your device is still functional before purchasing. You should be able to hold the charger on to check that the device will still charge and shows a charge screen. You can also gently press with a paperclip in the area where the button used to be to make sure the button electronics are still working properly. If either of these do not function properly this replacement will not fix your fitbit. Q&A Does it come with the wrist band? No, it is the piece that houses the button and where the charger plugs in. If I just lost my button and not the whole plastic piece can I use this as a fix? Yes, it will require you to remove the original plastic charging band and glue this in its place if yours is still there. Most people lose everything together so this is not normally the case though. Do I need to glue it? I highly recommend super gluing it on. It will hold in place by itself but the charger will want to pull it off when plugged in. Mine has not been glued since I test fit all the pieces, but you are more likely to have to come back to me to get another since it could fall off.
Replacement for Fitbit Charge HR charging band and button
Video on Installation: https://www.youtube.com/watch?v=t5aMuvxYyWE
3D Printed in USA
Super Glue Recommended for installation
1 piece design; no separate button or metal plates. It replaces them all.